Chucking work capacity RD. 2-5/l6”
Collet Chuck ( Round) l-3/4”
(Hexagon) l-l/2”
(Square) 1-3/l6”
Maximum Machining Length
Collet Chuck 3-3/l6”
Product length in the case of regrasping
machining by main spindle sub spindle
Minimun Machining Length
Collet Chuck 3/4”
Product length in the case of regrasping
Machining by main spindle sub spindle Workpiece dia.x l.5
Machining Capacity
Sub Spindle
Power Chuck Size 5”
Chucking work capacity, Round 2-5/l6”
Maximum Machining Length
Power Chuck 2”
Minimum Machining Length
Power chuck 3/4”
Main Spindle
Spindle nose A2-6
Spindle nose diameter 6-l/2”
I.D. of spindle 2-3/l6”
I.D. of Draw Pipe l.85”
Spindle speed range l33 to 4000 RPM
Spindle drive V Belt Direct Drive
Main Turret
Tooling stations 8
Distance across flat ll.023”
I.D. Tool Hole Size l”
Tool Shank Size 3/4”
Maximum Indexing Clearance l8”
Indexing Time 0.4 sec/pos
Main Turret
Maximum Slide Stroke
“X” axis 5.3l5”
“Z” axis 9.843”
Rapid Traverse Rate
“X” axis 394 IPM
“Z” axis 3941PM
Sub Spindle
Spindle Nose Flat
Diameter of Spindle Nose 5.3l5” dia.
I.D. of spindle l.378” dia.
I.D. of Draw Pipe l.l03” dia.
Spindle speed range 100 to 4000 rpm
Spindle drive V belt driect drive
Spindle motor (variable speed AC) AC 3/5 HP
Maximum Slide Stroke
“X” axis 8.07l”
“Z” axis 9.843”
Rapid Traverse Rate
“Z” axis 394 IPM
“Z” axis 394 IPM
Sub Turret
Installed condition Fix
Tooling station 6
Distance across flat 5.906”
I.D. Tool Hole Size l” dia.
Tool Shank Size 3/4” sq.
Maximum Indexing Clearance l3” dia.
Indexing Time 0.4 sec.
Hydraulic Equipment
Tank Capacity l0 gal.
Pump Motor 5/6 Gal/Min
Maximum Setting Pressure 640 PSI.
Coolant
Tank Capacity 32 gal.
Pump Motor l/4 HP
Pump Capacity 20/26 Gal/Min
Lubricating
Tank capacity 0.5 Gal.
Pump motor ACl00V 0.00 5HP
Maximum Setting Pressure 28 PSI
Intermittent Time l5 Min.
Chip Conveyor (option)
Type Hinge Type
Motor 0.27 IMP
Transfer Speed 33/40 IPM
Power Requirement
Voltage AC 200/220/230V
Power Capacity 27KVA